GreenEdge automotive Technical Data

Physical Form
Liquid - Water thin green liquid with low odor
pH - approx. 9.5 undiluted

Weight
8.33 lbs/liquid US gallon

Safety
NFPA/HMIS - 1/0/0/0
Wet Flammability - nonflammable
Dry Flame Spread - N/A
Volatility - no VOC¹s
Threshold Limit Value - Non-Toxic
Medical - Not considered a health threat. Non-irritating to normal skin.
Refer to MSDS.

Temperature Limits
32° F. to 220° F.

Limitations
For use on water tolerant materials

Applicable Test Requirements
As required by governing authority


Disposal
Non-toxic to environment, however, always check local laws concerning discharge before disposing.

Areas for Use
Any water washable surface, including floors, walls, concrete, machinery, metal parts, equipment, vehicles, protective gear, tile, porcelain, terrazzo, vinyl, plastics, wood, rubber, etc.

Tools for Application
Mops, pressure washers, garden type pump-up sprayers, automatic floor scrubbers, chemical inductors/proportioners

Coverage
100 to 5,000 sq ft per gallon, depending on application and method used. Refer to instructions.

Packaging
1 case (4 - 1 gallon)
5 US Gallon plastic pails
55 US Gallon plastic drums
Bulk (275 gallon containers or larger)

Shipping
DOT label not required - non-hazardous
Class 55


MATERIAL SAFETY DATA SHEET
Download this MSDS

MATERIAL SAFETY DATA SHEET

MANUFACTURER:

Emerald Edge Environmental, Inc.
414 21st Street S, Texas City, TX 77590
Phone: 800-458-2236 or 409-945-5333


SECTION I: IDENTIFICATION

PRODUCT: Green Edge
DESCRIPTION: All Purpose, Aqueous Based, 100% Biodegradable, Non-Toxic Automotive Cleaner/Degreaser


SECTION II: INGREDIENTS AND HAZARDOUS CLASSIFICATION

NON-HAZARDOUS SOLUTION

SARA HAZARD: TITLES III SECTION 313: Not Listed Fire (Section 311/312): None
OSHA: Not Listed NTP: Not Listed lARC: Note Listed

NOTE: As a result of the manufacturing process, Green Edge does not present the occupational health risks, if any, associated with exposure to its undiluted raw material ingredients.


SECTION III: HEALTH INFORMATION

INHALATION: No none problems with normal ventilation
INGESTION: Considered non-toxic (16 CFR 1500 3 code of Federal Regulations 16
Federal Hazardous Substances act Regulations Part 1500 3), however,
As with any cleaner, avoid ingestion.
EYE CONTACT: Avoid contact. Mild transient irritation and hazy vision due to dryness.
SKIN CONCTACT: Non-corrosive and non-irritating to normal skin.

EFFECTS OF OVEREXPOSURE:

INHALATION: Mild transient throat irritation
INGESTION: Mild Transient gastrointestinal irritation
EYES: Discomfort / dryness / irritation
SKIN: Mild transient redness, rash and/ or dryness


SECTION IV: OCCUPATIONAL EXPOSURE LIMITS

PEL: No OSHA PEL
TLV: No ACHIH TLV


SECTION V: EMERGENCY FIRST AID PROCEDURES

INHALATION: Not a known problem, however, if problems develop remove air.
INGESTION: Call physician or poison control center if swallowing large amounts is suspected
EYES: Wash affected area with water, reduce or discontinue contact.
SKIN: Flush with plenty of water.


SECTION VI: PHYSICAL DATA

Boiling Point: 212 degrees F. Vapor Pressure: MM/HG: <.01 @ 70 degrees F.
Vapor Density: Specific Gravity: Evaporation Rate: =H2O
1.00+/- .01
Solubility in Water: Comp;ete Odor: Mild hydrocarbon odor
Appearance: Water thin translucent liquid Color: Green
Ph: approx. 9.5 Melting Point: NA

Green Edge MSDS (con't.) Page 2 of 2

SECTION VII: FIRE AND EXPLOSION HAZARDS

Flash Point: NA
Volatile Organic Compounds (VOC's): None
Extinguishing Media: NA
Special Fire fighting Procedures: None
Unusual Fire/Explosion Hazards: None
NFPA Rating: 1/0/0/0


SECTION VIII: REACTIVITY DATA

Stability: Stable
Materials to Avoid: Materials known to cause violent reaction with water.
Conditions to Avoid: None
Hazardous Decomposition Products: None


SECTION IX: EMPLOYEE PROTECTION

Control Measures: Provide adequate ventilation
Respiratory Protection: None required
Protective Clothing: None required, however, for extended or frequent contact, rubber gloves are
recommended.
Eye Protection: Safety glasses/goggles are recommended, particularly if splashing
May occur or if high pressure washing creates a mist.
HMIS III Rating: 1/0/0/A (0=Minimal 1=Slight 2=Moderate 3=Serious 4=Severe A=Safety Glasses-
Goggles).


SECTION X: ENVIRONMENTAL PROTECTION

Special Precautions: None
Spill or Leak Precautions: None required. Rinse with water to eliminate potential for slips and falls.
Waste Disposal: Product will not harm environment if released in any quantity, however, any disposal must be in
accordance with all local, state and federal laws.


SECTION XI: TRANSPORTATION REGULATORY CONTROLS

DOT Classification: Class 55
Proper shipping name: Cleaning compound
Other Requirements: None
Hazard/Placard: None Required

THIS INFORMATION RELATES ONLY TO THE SPECIFIC MATERIAL DESIGNATED & MAY NOT BE VALID FOR SUCH MATERIAL USED IN COMBINATION WITH ANY OTHER MATERIALS OR IN ANY OTHER PROCESS. THE STATED M.S.D.S. IS RELIABLE TO THE BEST OF THE COMPANY'S KNOWLEDGE & BELIEVED TO BE ACCURATE AS OF THE DATE INDICATED. HOWEVER, NO REPRESENTATION, WARRANTY OR GUARANTEE OF ANY KING, EXPRESSED OR IMPLIED, IS MADE AS TO its ACCURACY, RELIABILITY OR COMPLETENESS & WE ASSUME NO RESPONSIBILITY FOR ANY LOSS, DAMAGE OR EXPENSE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF USE. IT IS THE USER'S RESPONSIBILITY TO SATISFY HIMSELF OR HERSELF AS TO THE SUITABLENESS & COMPLETENESS OF SUCH INFORMATION FOR HIS OR HER OWN PARTICULAR USE.

Date prepared 01/15/10
Symbols: NA= Not Applicable F=Fahrenheit C=Centigrade


Website designed
and maintained by

This is a VBODesigns.com web site design, click here to visit VBO!
  This is a VBODesigns.com web site design, click here to visit VBO!

SITE SPECIFICATIONS
This site is Firefox, Internet Explorer enhanced and best viewed at 1024 X 768 16bit color.
Copyright 2002-2015 SSPEnviro.com, E3enviro.com and or VBO Designs. All rights reserved.
Do not duplicate or redistribute in any form.